20W D-class power amplifier for higher output level and less
power consumption with no heat sink.
Dedicated 4-inch full range driver for clear audio reproduction.
Traditional rugged enclosure of aluminum die-cast with the
physically identical height and width to the current B-series.
Flat panel design to avoid inadvertent power-off or level change.
Auto Stand-by mode (compliant to ErP directive) for energy saving.
Detachable IEC type power inlet with multi-voltage power handling.
Newly designed mounting bracket (EB-6301) for wall mounting with
variable angle adjustments.
Enclosure type: closed
Unit: 4" full range
Frequency response: 70 Hz ? 15k Hz
Sound Pressure Level: 85dB / W (1m)
Maximum SPL: 98dB Amplifier Section
Connector: 1/4" TS Phone (unbalanced)
Input Impedance: 10k ohm or more
Rated Output: 20W
Distortion (T.H.D.): 0.05% (1kHz / 1W output)
Residual Noise: -70dBV or less
Input Sensitivity: 1/4" TS phone: -14dBV (0.2Vr.m.s.)
Auto Stand-by: active after approx. 25 min. of continuous input lower than the threshold level